Before starting the small batch concrete mixer, operators firstly need to inspect that whether the rotating part and the barrel is scratched or not. If there is scratch, users should timely make adjustments. Clean up the sundries in the barrel. Before starting up the concrete mixer, the barrel needs to be controlled by users. The rotating direction of mixer shaft should be the same as the direction shown on the barrel. The concrete material charged into the barrel must be removed from metal or other sundries. Adjust the timing of the agitator according to the mixing time. Users need cut off the electricity when adjusting the time of the agitator.
Henan Daswell Machinery Co., Ltd,is a professional manufacturer and trader specializing in the research, development and production of construction machinery for nearly 30 years. Our main products are as follows:diesel engine concrete mixer,concrete pumps,etc. We will provide you with the best product and service.
Press the start button, the mixing shaft will put the mixing blades and mixing barrel in motion. The concrete mixer will automatically stop working when the set time arrives. Before discharging concrete concrete mixers, users should firstly close down the concrete. Then open the locking pin, move the handle to make the barrel rotate to a certain position. Use the locking pin to fix the mixing shaft. Lastly, discharge the concrete. After discharging the concrete material mini wheel loader, replace the barrel by hand and locate the mixing drum by using the locking pin. Pour the water into the mixing drum to clean up the barrel with the rotation of the drum. People can also use the dried sand to clean up the concrete mixer.